|
PERFECT-SURFACE COPPER+: Mont Blanc uses extremely
high purity Perfect-Surface Copper+ (PSC+) conductors. All conductors are solid, which prevents strand
interaction, a major source of distortion. Surface quality is critical because a conductor can be
considered as a rail-guide for both the electric fields within a conductor, and for the magnetic fields
outside the conductor. The astonishingly smooth and pure Perfect-Surface eliminates harshness and greatly
increases clarity compared to OFHC, OCC, 8N and other coppers. The superior purity of PSC+ further
minimizes distortion caused by grain boundaries, which exist within any metal conductor.
DIELECTRIC-BIAS SYSTEM (patent pending): Unfortunately, because insulation stores and releases energy, it
is also a "dielectric." In a cable application, all released energy is distortion. The misnomer "break-in"
is often used to describe the pronounced improvement in performance as the dielectric adapts to a charged
state as the cable is used. Whenever a cable does not have a charge on it, it is re-adapting to an
uncharged state; it is becoming new again. By maintaining a 36 volt dielectric-bias, far above the voltage
of delicate audio signals, the DBS system provides considerably better transparency and dynamics than is
possible even from a cable in continuous use. It takes a couple of weeks for the DBS system to reach
maximum performance. Since DBS battery packs are attached when Mont Blanc cables are first terminated, Mont
Blanc will be approaching or at peak performance by the time it is installed in your system. Since there is
no "load" on the two standard hardware-store batteries, they will last for years. A test button and LED
allow for occasional verification of battery performance.
COUNTER SPIRALING "EARTH FEATURE"
GEOMETRY: Mont Blanc and the other AQ "Earth Feature" cables have an inner circular array of positive
conductors spiraling in one direction. Around this inner group, are the negative conductors, spiraling in
the opposite direction. Even
while the positive and negative conductors are crossing each other instead
of being parallel, the relationship between the positive and negative groups is fixed and non-changing,
adhering to one of AudioQuest's most basic design tenets: consistency. The result is an astonishing
clarity, like focusing a camera lens you had no idea was so far out of focus. SST (Spread Spectrum
Technology): Any single size or shape of conductor has a specific distortion profile. Even though radially
symmetrical conductors (solid round or tubular) have the fewest discontinuities, any particular size does
have a sonic signature. SST uses a precise combination of different size conductors in order to
significantly reduce the audibility of these character flaws. The four different SST-determined conductor
sizes used in Mont Blanc allow an exceptionally clear, clean and dynamic sound.
CONDUCTIVE
INSULATION: The five negative conductors in Mont Blanc are insulated with partially conductive
carbon-loaded polyethylene. This remarkable material damps radio-frequency garbage from being fed back into
the amplifier. The sonic benefit is exactly the same reduction in "hash" and better dimensionality that
comes whenever RF garbage is reduced in an audio circuit.
TERMINATIONS: AudioQuest offers a wide
range of high quality connectors that allow Mont Blanc to be securely attached to any type of equipment. AQ
ends are dull looking because the silver (or gold) is plated directly over the connector. There is no harsh
sounding shiny nickel layer underneath. AQ spade lugs are plain looking and soft because pure copper is
soft. Also, compressibility facilitates a higher quality connection. AQ spade lugs are available in several
sizes. AQ PSC Benda-Pins fit all equipment, except components accepting only a banana plug or BFA
connector, in which case the AQ Crimp BFA/Banana provides unprecedented performance at a fraction the cost
of those not-so-good sounding big "eye-candy" versions.
BIWIRING: When possible, running separate
conductors or separate cables to the treble and bass halves of a speaker will considerably reduce
distortion. BiWiring works because cable causes distortion, which can be minimized by keeping the bass
energy out of the treble cable. Mont Blanc is an ideal full-range cable. It can also be used as a double
pair for maximum benefit from BiWiring. Mont Blanc has also been designed to make it possible to
Single-BiWire. The five conductors per polarity have been chosen and arranged so that they may be divided
into two groups, allowing Mont Blanc to be prepared with four connections on the speaker end.
|
Questions?
1.973.239.1799
